curing temperature

意思翻译

[化工]固化温度；加硫

相似词语短语

curing───[化学]固化；（肉、鱼等的）[食品]腌制，调制；医治；食物加工法；cure变形

temperature───n.温度；体温；气温；发烧

curing marijuana───治疗**

critical temperature───[物][电子]临界温度；n.临界温度

curing ballots───养护选票

post curing───后固化；后熟化

curing time───固化期，熟化期，熟化时间；硬化时间，[化工]固化时间

ballot curing───选票补救

temperature outside───室外温度

双语使用场景

Take the average temperature in the curing time as curing temperature.───养护温度取各湿喷桩养护期的平均气温。

This may be done in a reciprocating screw machine where one charge at a time is brought to curing temperature.───这可能是在做往复螺杆机，其中一名主管在一个时间是带来的固化温度。

curing temperature and alkali contents of cement on expansion of mortar bars are investigated.───研究了养护温度和水泥碱含量（质量分数，下同）与硅质集料砂浆试样膨胀的关系。

The influence of concentration of the finishing agent, cross-linking agent and curing temperature on the finishing result was investigated.───探讨了整理剂浓度、交联剂浓度、焙烘温度等对整理效果的影响，并在此基础上优化工艺参数。

The influence of treating methods of the cotton fabric, curing temperature, addition of salt and bath ratio upon dyeing are also discussed.───文章还讨论了棉织物处理方式、焙烘温度、盐及染色浴比对染色的影响。

the strength and durability of RPC gradually increase with the curing temperature increased.───随着养护温度的提高，RPC强度和耐久性能逐渐提高。

Effects of graphite content, curing time and curing temperature on the properties of the composite were studied with orthogonal test.───采用正交试验方法研究了石墨含量、固化时间以及固化温度对复合材料的影响。

Of course, curing temperature is not possible.───当然固化温度并不是越高越好。

The influence of curing reaction heat on curing temperature field of cubic rubber block and tire was investigated.───探讨长方体胶块和轮胎硫化反应热对硫化温度场的影响。

英语使用场景

It's curing temperature high and difficult to molding.

For traditional thermal curing powder coatings, there has a big limit of high curing temperature.

Of course, curing temperature is not possible.

Prolongation of the lay-by time of HAA/T-12 and raising the curing temperature will achieve the same results in shortening the pot-life of the binder curing reaction.

Effect of curing temperature, curing time, resistance to media, kind and volume of the sand-laden fluid, and particle size of proppant on fibre compound sand control system were discussed.

The hardness of highlights oil and different light oil have different best curing temperature.

A system of epoxy resin , anhydride and accelerator was selected which efficiently promoting the curing speed and decreasing curing temperature.

When curing temperature was preferred to be 260 and the percentage of solidification agent was 3 %.

Through analyzing each factor such as concentration of citric acid and chitin, curing temperature as well as curing time, the optimum condition is defined for the anti-crease finish.

curing temperature